|
|
|
|
|
|
|
 |
 |
 |
|
EMTEK Marrietta-6
Monolithic (One Piece) HANDLESETS Marietta-6 handlesets are custom manufactured to fit a door with a center to center face bore of 6" (See Fig. 1 below). Two holes 2 1/8" are required, one for the deadbolt mechanism and one for the lever/knob. These two holes MUST be spaced 6" from center to center (see Fig. 1 below). Each hole is standard door prep (see Fig. 2 below). If your door is already drilled and the two holes measure anything other than 6" from center to center, the Marietta-6 handleset WILL NOT FIT your application, you will will need a sectional (two-piece) handleset (one where the deadbolt and handle are separate). If your two holes measure 5-1/2" from center to center, see Marrietta-5.5 If you have a modern door or you are buying an off-the-shelf door from a home center and it is drilled for a knob and deadbolt, most likely the spacing between the two holes will be 5 1/2" center to center. If you have not yet received your door contact the vendor and double check the specifications, some door and window millworks make their own rules and don't follow the door hardware industry standards. You will be asked to verify that your hole dimensions as per Fig. 1 and Fig. 2 below at the time you place your order, if not verified your order will be delayed until we receive e-mail confirmation your bore dimensions are correct for the product. It is important that you accurately measure the below dimensions on your door. Guessing or assumptions will only cause you delays and add to your shipping costs if you receive your handleset only to discover existing dimensions on your door are not correct for the product. Return Policy on Emtek Products – See Returns and Exchange Policy |
|||
|
|
||||
|
||||
